header valves
Valves & Actuation
Series 94 on Type 57 Fast Pack

Actuated Plastic Butterfly Valves

Electric Series 94 on Type-57P Butterfly Valve

Butterfly valves up to 4" can be actuated with the Series 94 electric actuator. The Series 94 actuator is a basic electric actuator designed for smaller quarter-turn valves, and is a good low-cost alternative to larger electric actuators. The Series 94 actuators have a thermally protected, bi-directional, capacitor run motor with a permanently lubricated gear train. Because of their size, the Series 94 actuators have a short open/close time, approximately 5 seconds, and a weight of only 3.5 lbs.

Resources

Data Sheet

Ideal Applications Include:

Locations with no air supply or colder temperatures, smaller valves, low-cost applications

Specifications

Sizes:

A94, B94

Voltage:

120 VAC 1Ph 50/60 Hz (Other Options Available)

Conduit Entry:

Two ½" NPT

Switches:

Two single pole, double throw (SPDT), 15 Amp rated

Torque:

150-300 in-lbs

Amp Draw:

A94: 0.5A, B94: 0.8A

Max Ambient Temperature:

150° F

Cycle Time per 90 degrees:

5 seconds

Features/Benefits

  • Motor – Reversing, brushless, capacitor run 120 VAC 50/60 Hz single phase
  • Overload Protection – Integral thermal overload protection for motor windings with automatic reset
  • Gear Train – Permanently lubricated
  • Corrosion Resistant Housing – Zytel FR50 engineered resin with stainless steel trim
  • ISO mounting configuration
  • Conduit – Two ½" NPT conduit entries to eliminate cross feed between control, feedback, and power signals
  • Position Indication – Highly visible position indicator for positive position of the valve, even at a distance
  • Declutchable Manual Override – Push down on handle and rotate in appropriate direction (CCW for open, CW for close)
  • Limit Switches – Standard end of travel limit switches can be used for light indication (NOT to be used with PLC for position indication)
  • Corrosion resistant mounting – Mounting is with PPG or stainless steel bracket, stainless steel coupling, and stainless steel hardware
  • CE Compliant Motor – All 120 VAC and 220 VAC motors are CE compliant and stamped as such
  • Extended Duty Cycles – Our extended duty cycles are ideal for modulating and high cycling applications
  • Output Torque – Series 94 electric actuators have an output torque range from 150 in/lbs to 300 in/lbs
  • Enclosure – Type 4X
  • RoHS Compliant

Options

  • Auxiliary (additional) limit switches
  • Feedback potentiometer
  • Heater and thermostat
  • Positioner (Modulating PCB)
  • Mechanical brake
  • Transmitter
  • Cycle length control module
  • Two-wire control
  • Center-off
  • Failsafe battery back up (Protek)
  • Various voltages
  • Local Remote Station